Direct-fit aftermarket replacement, machined from Mild Steel at the Enex workshop in Malaga, Perth WA. Made to original equipment spec — no rework, no spacer kits.
This shim sets the spacing, alignment and end-float that keep a trailer joint running true - it locates components and takes thrust so they don't wander or bind. It's a setting shim used to dial in clearance and end-float. Worn or crushed, it lets parts move where they shouldn't. EE025 restores the correct dimension. Confirm fit by sending your worn part, photo or dimensions.
Quotes returned in 24-48 hours · Volume discounts at 10+
Quote requests typically returned within 24-48 HOURS. Australia-wide freight.
Spacers, sleeves and washers wear quietly. Look for end-float or sideways play that wasn't there before, fretting or bright rub marks on the faces, a crushed or stepped profile, or components that no longer sit square. Renewing them is cheap insurance against accelerated wear in the pins and bushes they locate.
Made from Mild Steel - readily machined and welded - the practical choice for spacers, shims, plates and retainers.
If you're unsure EE025 matches your worn part, photograph it with a tape measure across the critical dimensions and email contact@enexengineering.com.au. We'll confirm fit before you commit.
Lead time varies by current production load. Send the part number and we'll come back with current availability and lead time within 24-48 hours. Australia-wide freight, tracked door-to-door.
Yes. Volume pricing applies at 10+ units. Email contact@enexengineering.com.au with your fleet sheet for a tailored quote.
Yes. Machined at the Enex workshop in Malaga, Western Australia, from materials supplied through Australian distributors.
Yes. Spacers, shims and washers are routinely cut to a range of thicknesses to dial in the correct end-float. Tell us the gap you need to take up and we'll machine to suit.
Yes. Send the worn part or the measurement and we'll machine to match - including non-standard thicknesses that are hard to buy off the shelf.
Photograph the worn part with a tape measure across the critical dimensions and email contact@enexengineering.com.au. We'll confirm fit before you commit.
