Direct-fit aftermarket replacement, machined from Gr250/350 at the Enex workshop in Malaga, Perth WA. Made to original equipment spec — no rework, no spacer kits.
This spacer sets the spacing, alignment and end-float that keep a trailer joint running true - it locates components and takes thrust so they don't wander or bind. It works in the brake S-cam assembly, where wear puts slack into the brakes. Worn or crushed, it lets parts move where they shouldn't. EE033 restores the correct dimension. Confirm fit by sending your worn part, photo or dimensions.
Quotes returned in 24-48 hours · Volume discounts at 10+
Quote requests typically returned within 24-48 HOURS. Australia-wide freight.
Spacers, sleeves and washers wear quietly. Look for end-float or sideways play that wasn't there before, fretting or bright rub marks on the faces, a crushed or stepped profile, or components that no longer sit square. Renewing them is cheap insurance against accelerated wear in the pins and bushes they locate.
Made from Gr250/350 - a strong, weldable structural-grade steel that holds its shape under load.
If you're unsure EE033 matches your worn part, photograph it with a tape measure across the critical dimensions and email contact@enexengineering.com.au. We'll confirm fit before you commit.
Lead time varies by current production load. Send the part number and we'll come back with current availability and lead time within 24-48 hours. Australia-wide freight, tracked door-to-door.
Yes. Volume pricing applies at 10+ units. Email contact@enexengineering.com.au with your fleet sheet for a tailored quote.
Yes. Machined at the Enex workshop in Malaga, Western Australia, from materials supplied through Australian distributors.
Yes. Spacers, shims and washers are routinely cut to a range of thicknesses to dial in the correct end-float. Tell us the gap you need to take up and we'll machine to suit.
Yes. Send the worn part or the measurement and we'll machine to match - including non-standard thicknesses that are hard to buy off the shelf.
Photograph the worn part with a tape measure across the critical dimensions and email contact@enexengineering.com.au. We'll confirm fit before you commit.
